It’s not uncommon to promote a server from slave to master. One of the key things to protect your data integrity is to make sure that the promoted slave is permanently disconnected from its old master. If not, it may get writes from the old master, which can cause all kinds of data corruption. MySQL [...]
Disconnecting a replication slave is easier with MySQL 5.5+ (RESET SLAVE vs. RESET SLAVE ALL)
April 17, 2013 By 2 Comments
Impact of memory allocators on MySQL performance
July 5, 2012 By 11 Comments
MySQL server intensively uses dynamic memory allocation so a good choice of memory allocator is quite important for the proper utilization of CPU/RAM resources. Efficient memory allocator should help to improve scalability, increase throughput and keep memory footprint under the control. In this post I’m going to check impact of several memory allocators on the [...]
ext4 vs xfs on SSD
March 15, 2012 By 26 Comments
As ext4 is a standard de facto filesystem for many modern Linux system, I am getting a lot of question if this is good for SSD, or something else (i.e. xfs) should be used. Traditionally our recommendation is xfs, and it comes to known problem in ext3, where IO gets serialized per i_node in O_DIRECT [...]
Percona Server vs MySQL on Intel 320 SSD
February 23, 2012 By 21 Comments
If you are terrified by the stability of the results in MySQL in my previous post, I am going to show what we can get with Percona Server. This is also to address the results presented there Benchmarking MariaDB-5.3.4
Benchmarking Galera replication overhead
October 13, 2011 By 12 Comments
When I mention Galera replication as in my previous post on this topic, the most popular question is how does it affect performance. Of course you may expect performance overhead, as in case with Galera replication we add some network roundtrip and certification process. How big is it ? In this post I am trying [...]
MySQL versions shootout
October 10, 2011 By 6 Comments
As part of work on “High Performance MySQL, 3rd edition”, Baron asked me to compare different MySQL version in some simple benchmark, but on decent hardware. So why not.
Aligning IO on a hard disk RAID – the Theory
June 9, 2011 By 18 Comments
Now that flash storage is becoming more popular, IO alignment question keeps popping up more often than it used to when all we had were rotating hard disk drives. I think the reason is very simple – when systems only had one bearing hard disk drive (HDD) as in RAID1 or one disk drive at [...]
Scaling problems still exist in MySQL 5.5 and Percona Server 5.5
May 20, 2011 By 11 Comments
MySQL 5.5 and Percona Server 5.5 do not solve all scalability problems even for read only workloads. Workloads which got a lot of attention such as Sysbench and DBT2/TPC-C scale pretty well a they got a lot of attention, there can be other quite typical workloads however which do not scale that well. This is [...]
Using Flexviews – part two, change data capture
March 25, 2011 By 26 Comments
In my previous post I introduced materialized view concepts. This post begins with an introduction to change data capture technology and describes some of the ways in which it can be leveraged for your benefit. This is followed by a description of FlexCDC, the change data capture tool included with Flexviews. It continues with an [...]
PBXT in tpcc-like benchmark
June 2, 2010 By 10 Comments
Finally I was able to run PBXT 1.0.11 pre-GA in tpcc-like workload, apparently there was bug with did not allow me to get the result earlier, and I am happy to see that PBXT team managed it. For initial runs I took tpcc 100 warehouses ( about 10GB of data) which fully fits into memory [...]
